How to Install Wall to Wall Carpet Yourself?

How to Install Wall to Wall Carpet YourselfAre you planning to lay a new carpet in your room all by yourself? If yes, you will find this article extremely useful. Here, we have discussed all the steps of installing a wall to wall carpet. Read through the discussion carefully and begin the installation job.

Step 1: You will need to begin by measuring the room. This step is important for determining how much carpet is required for covering the entire floor of the room. Measure the room’s length and width carefully. Don’t forget to add a few additional inches to both the room’s length and width for allowing extra carpet for doorways and thresholds.

Step 2: In the next step of the installation procedure, you will need to check for squeaks. Take out the shoe molding and carefully inspect the sub-floor for squeaks. If you locate any squeak, mark it with the letter “X”. Now, insert a medium-sized drywall screw into the room’s sub-floor on the marked area, down into its joist.

Step 3: This step involves installation of tack strips all across the room’s perimeter. When doing so, you will have to maintain a 3/8 inch gulley between the base-board and tack strip. Ideally, you should determine the exact distance by positioning your fingers between the tack strip and the wall. Experts say that the tack strips used for this purpose should be wide.

Step 4: In this step, you will need to lay out the carpet cushion. You must always buy a high quality carpet cushion; this is important for protecting both your feet and the carpet. The laying job should begin from any one corner of the room. Starting from a corner, you should roll out the entire strip carefully so that there’s no visible gap after carpet installation. Don’t miss giving the space a clean look by making relief cuts wherever necessary. Finally, thoroughly staple the carpet cushion down at every 2 ft or so.

Step 5: This step is about rolling out and fitting the carpet, which make it the most important step of this installation process. You will need help from another adult member of your family to bring the carpet roll to the room as usually these rolls are extremely heavy. Roll the carpet out and place it properly on the floor; there should be enough excess on the walls.

For finding out whether the carpet edges are parallel to their corresponding walls, use a knitting needle to draw a line across the tuft adjacent to the base-board. Make a horizontal cut and a couple of vertical cuts along that line; this will form a window. Repeat all these steps till the wall’s far end. If required, use a knee kicker for adjusting the carpet so that it is flush to the base-board.

Step 6: You are now ready to begin carpet installation. Installation should be started from any corner of the room. After every 5 inch or so, place a nail and hammer it onto the carpet. This will allow the carpet to stay in place permanently.

Step 7: While trimming the carpet along the wall, tack it down into the space between the base-board and tack strip; the term used for this part is “gulley”. For doing this job, you will need a plastic paddle.

Step 8: Once the carpet is installed, get the shoe molding replaced and vacuum the surface well.

These were the few steps that make up the carpet installation procedure. If the steps appeared to be too complex, you can hire professionals to do the job for you. For that, you will have to get in touch with a company offering carpet installation and cleaning service.